Pilot lets you control compatible Apple Vision Pro apps from your iPhone or iPad.
Requirements
To use Pilot, you need:
- An iPhone or iPad running the supported version of iOS or iPadOS
- An Apple Vision Pro running a compatible app that supports Pilot
- Both devices connected to the same local network
- Local Network permission enabled for Pilot
Getting Started
- Open Pilot on your iPhone or iPad.
- Allow Local Network access when prompted.
- Make sure your compatible Vision Pro app is running.
- Wait for the app to appear under Available Apps.
- Select the app to connect.
- Use the listed controls to start or stop available actions.
Troubleshooting
If no apps appear:
- Confirm that your iPhone or iPad and Apple Vision Pro are on the same Wi-Fi network.
- Confirm that Local Network access is enabled for Pilot in Settings.
- Restart Pilot.
- Restart the compatible Vision Pro app.
- Check that the Vision Pro app supports Pilot.
- Avoid guest networks or restricted office networks that block local device discovery.
If Pilot cannot connect:
- Make sure the target Vision Pro app is open and active.
- Move both devices onto the same Wi-Fi network.
- Turn Wi-Fi off and on again on both devices.
- Close and reopen Pilot.
- Close and reopen the compatible Vision Pro app.
If controls do not appear:
- The connected app may not have shared any remote actions.
- Update both Pilot and the compatible Vision Pro app to the latest versions.
- Disconnect and reconnect from Pilot.